Heli-Max HMXE0250 - Manual (Page 8)

❏
6. Install the engine onto the mount using thread locker
and the four 3x16mm screws provided.
❏
7. Install the right side frame using the 3x12mm screws and
large washers (use thread lock). Before tightening the bolts
place the frames on a flat surface to ensure they are parallel.
Tighten the bolts. Check the left side engine mount bolts
(factory-assembled) for thread locker and apply if necessary.
UPPER FRAME AND SERVO FRAME INSTALLATION
Bag 2 Contents: Assembled Main Mechanics
Bag 9 Contents: Servo Tray Set, 3x12mm Cap Screw (4),
3x8mm Self-Tapping Screw (2), 3x8mm Mashine Screw (2),
3x8x1mm Flat Washer (4), 3x12mm Self-Tapping Screw
❏
1. Slide the lower fan shroud over the engine as shown in
the picture above and install the 3mm self-tapping screw as
shown. Repeat on the opposite side.
❏
2. Slide the rear portion of the upper frame into the lower
frame. Align the upper and lower fan shroud and slide the
upper frame forward while pressing downward. The clutch
bell and pinion must clear the main gear before the upper
frame will slide down into its proper location.
8