Heli-Max HMXE0250 - Manual (Page 31)

31
❏
2. Trim the front of the body as shown above. Make a clean
cut by making several passes with a hobby knife. Mark the
body 5/8" [16mm] up from the back edge and 5/8" [16mm]
right. Drill 1/4" [6.4mm] holes for the rubber grommets. Install
the grommets into the body.
❏
3. Install the front body clamp using two 3x8mm self-
tapping screws. Please note that the wider end should face
the back of the canopy.
❏
4. Depending on your muffler, it may be necessary to cut
the body for clearance. Leave at least 1/4" [6.4mm] between
the body and muffler. Mount the body by sliding the canopy
latch onto the “L” bracket on the servo tray. Lift up the back
portion of the body and push the grommets onto the rear
body mounts.
❏
5. Once the body is installed, trim and test fit the
windshield. When satisfied with the fit, drill 1/16" [1.5mm]
holes at the locations shown and use 2x3mm self-tapping
screw to attach the windshield. Repeat for the other side of
the body.
DECALS
❏
Clean the body thoroughly with glass cleaner to remove
any mold release left over from manufacturing. Spraying glass
cleaner on the body before applying the decals enables you
to reposition them until they are perfectly placed. Once in
place, use a squeegee to remove the cleaner, allowing the
decals to “stick” in place.