HONDA 2003 S2000 - Owner's Manual - Manual (Page 171)

Remove the reserve tank from its
holder by pulling it straight up.
Drain the coolant, then put the
tank back in its holder.
When the coolant stops draining,
tighten the drain plug at the
bottom of the radiator.
Apply non-hardening sealant to the
drain bolt threads, put a new
washer on the drain bolt, and
reinstall the bolt in the engine
block. Tighten it securely.
Tightening torque:
Loosen the bleeder bolt on top of
the engine, and remove the
bleeder cap near the engine oil fill
cap. 5.
6.
7.
Cooling System
Maintenance 168
RESERVE TANK CAP
HOLDER RESERVE TANK
BLEEDER BOLT
61 lbf·ft (83 N·m , 8.5 kgf·m)
Main Menu Table of Contents