HONDA 2003 S2000 - Owner's Manual - Manual (Page 204)

Pull the bulb straight out of its
socket.
Push the new bulb straight into
the socket until it bottoms.
Put the bulb holder back into its
hole in the lens, and turn it
clockwise until it locks.
Test the lights to make sure the
new bulb is working.
Use a small flat blade screwdriver
to pry carefully on the back edge
of the side turn signal assembly
until it pops out of the body.
Put the side turn signal assembly
back into the body, front first.
Push on the back edge until it
snaps into place.
Turn the bulb holder one-quarter
turn counterclockwise to remove it
from the lens.
1.
2.
3.
4.
5.
6.
Lights
Maintenance
Replacing a Side Turn Signal Bulb
201
Main Menu Table of Contents