HONDA 2000 Insight - Owner's Manual - Manual (Page 194)

Lights
4. Unclip the end of the hold-down
wire from its slot. Pivot it out of
the way and remove the bulb.
5. Insert the new bulb into the hole,
making sure the tabs are in their
slots. Pivot the hold-down wire
back in place and clip the end into
the slot.
6. Install the rubber seal over the
back of the headlight assembly.
Make sure it is right side up; it is
marked "TOP."
7. Push the electrical connector onto
the tabs of the new bulb. Make
sure it locks in place.
Turn on the headlights to test the
new bulb.
8. Reinstall the radiator reserve tank.
Replacing the Front Parking
Lights
1. Remove the socket from the
headlight assembly by turning it
one-quarter turn counterclockwise.
2. Pull the bulb straight out of its
socket.
3. Install the new bulb into the
socket.
4. Insert the socket back into the
headlight assembly. Turn it
clockwise to lock it in place.
5. Test the lights to make sure the
new bulb is working.
Replacing the Front Side Marker/
Turn Signal and Parking Light
Bulb
1. If you are changing the bulb on
the driver's side, start the engine,
turn the steering wheel all the way
to the right, and turn off the
engine. If you are changing the
bulb on the passenger's side, turn
the steering wheel to the left.
CONTINUED
Maintenance
Main Menu Table of Contents