IC Realtime Combo Series: 8 Channel DVR with built-in 10 LCD monitor User Manual
Page 118
109
Parameter Function
Period
z
Motion detection function becomes activated in the specified
periods.
z
There are six periods in one day. Please draw a circle to enable
corresponding period.
z
Select date. If you do not select, current setup applies to today only.
You can select all week column to apply to the whole week.
z
Click OK button, system goes back to motion detection interface;
please click save button to exit.
Anti-dither System only memorizes one event during the anti-dither period. The
value ranges from 3s to 600s.
Normal
out
z
There is 1-channel alarm output.
z
Corresponding to motion detection alarm output port(multiple
choices)
z
Enable alarm activation function. You need to select alarm output
port so that system can activate corresponding alarm device when
alarm occurs.
Alarm
latch
System can delay the alarm output for specified time after alarm end
The value ranges from 10s to 300s.
Show
message
System pops up the alarm messages in the monitor interface.
Buzzer
Once you check the box here, the buzzer beeps when an alarm
occurred.
Alarm
upload
System can upload the alarm signal to the centre (Including alarm
centre.
Record
channel
System auto activates motion detection channel (multiple choices) to
record once alarm occurs (working with motion detection function).
Please note current device shall be in alarm record period (Chapter
7.3.2.3 Schedule) and you have enabled the schedule record function
in chapter 7.3.3.3 Record.
Record
latch
System can delay the record for specified time after alarm ended. The
value ranges from 10s to 300s.
If you enabled this function, System can send out email to alert you
when alarm occurs and ends.
Tour
z
Display the selected video in local monitor window.
z
Tour interval and tour mode are set in 10.2-inch combo DVR local
menu (chapter 5.3.9 Display )
PTZ
Activation
z
Here you can set PTZ movement when alarm occurs. Such as go to
preset x when there is an alarm.
Capture
You need to input capture channel number so that system can backup
motion detection snapshot file.
Matrix
Enable
Please note this function is valid in motion detect mode.
Check the box here to enable video matrix function. Right now system
supports one-channel tour function. System takes “first come and first
serve” principle to deal with the activated tour. System will process the
new tour when a new alarm occurs after previous alarm ended.
Otherwise it restores the previous output status before the alarm
activation.