IC Realtime Combo Series: 8 Channel DVR with built-in 10 LCD monitor - Manual (Page 23)

14
Please use the screwdriver to secure the data cable and the 10.2-inch combo DVR cable socket.
Please make sure it is firm otherwise it may result in network problem and etc. Then you can use
the Ping command to test the network cable connection status. You need to check the cable
connection if the request time is out.
Figure 3-2
3.5 HDD Installation
This series 10.2-inch combo DVR has only one 2.5-inch SATA HDD.
You can refer to the Appendix for recommended HDD brand. You can select the capacity as your
requirement.
Please follow the instructions below to install the HDD.
1 . Turn the screw of the HDD cover and
then remove the HDD cover
2. Line up the HDD to the HDD slot and then
install