IC Realtime Combo Series: 8 Channel DVR with built-in 10 LCD monitor - Manual (Page 125)

116
Parameter Function
Channel It is the monitor channel.
Snapshot mode
There are two modes: Timing and activation.
Frame rate You can select from the dropdown list. The value ranges from
1f/s to 7f/s.
Resolution
The channel 1 supports D1/CIF/QCIF.
The channel 2 to channel 8 supports CIF/QCIF.
Quality
You can select from the dropdown list. Here is for you to set
video quality.
There are six options: 10％, 30％, 50％, 60%， 80%，100%.
The 100% is the best quality for this series product.
7.3.3.7 Abnormity
The abnormity interface is shown as below. See Figure 7-52.
Figure 7-52
Please refer to the following sheet for detailed information.
Parameter Function
Event
Type
z
The abnormal events include: no disk, no space, disk error, net error.
z
You need to draw a circle to enable this function.(Multiple choices)
Normal
Out The corresponding alarm activation output channel when alarm occurs,
There is one channel.
Latch The alarm output can delay for the specified time after alarm stops.
Then system disables alarm and corresponding activation output.
The value ranges from 1s to 300s.
Send
email If you enable this function, system can send out email to alarm the
specified user.
Alarm
upload System can upload the alarm signal to the network (including the alarm
centre.)
Show
message System can display alarm information in local 10.2-inch combo DVR
screen.