IC Realtime H.264E Hybrid DVRs 4/8/16-CH Analog + 4/8/16-CH IP - Manual (Page 134)

124
Parameter Function
Protocol Select the corresponding dome protocol.(such as PELCOD)
Address Set corresponding dome address. Default value is 1. Please note your
setup here shall comply with your dome address; otherwise you can
not control the speed dome.
Baud
Rate Select the dome baud rate. Default setup is 9600.
Data Bit Default setup is 8. Please set according to the speed dome dial switch
setup.
Stop bit Default setup is 1. Please set according to the speed dome dial switch
setup.
Parity Default setup is none. Please set according to the speed dome dial
switch setup.
Save You can click save button after you complete setup for one channel, or
you can complete the whole setups and then click save button.
Refresh Click this button to get device latest configuration information.
7.3.2.9 Default & Backup
Default: Restore factory default setup. You can select corresponding items.
Backup: Export current configuration to local PC or import configuration from current PC.
Please refer to Figure 7-45.
Please note system can not restore some information such as network IP address.
Figure 7-45