Interlogix GE-DSH-73 Series User Manual - Manual (Page 30)

Chapter 2: Installation
26 GE-DSH-73/DSH-82 and DSH-82-PoE User Manual
Figure 2-13 : Wall mounting
Wiring the Power Inputs
The 6-contact terminal block connector on the top panel of GE-DSH-82-PoE is used
for two DC redundant power inputs.
NOTE: This product is intended to be supplied by a UL Listed Direct Plug-In Power Unit
marked "Class 2" or "LPS" and output rated 48 VDC, 380 mA minimum.
Please follow the steps below to insert the power wire.
1. Insert the positive / negative DC power wires into the contacts 1 and 2 for POWER
2, or 5 and 6 for POWER 1.