Interlogix NVR 50 User Manual - Manual (Page 18)

2BChapter 3: Getting started
12 TruVision NVR 50 User Manual
Using the setup wizard
The TVN 50 has an express installation wizard that lets you easily configure
basic NVR settings when first used. It configures all cameras simultaneously.
The configuration can then be customized as required.
By default the setup wizard will start once the NVR has loaded. It will walk you
through some of the more important settings of your NVR.
Any changes you make to a setup configuration page are saved when you exit
the page and return to the main wizard page.
Note: If you want to set up the NVR with default settings only, click Next in each
screen until the end.
To quickly set up the TVN 50:
1. Connect all the devices required to the back panel of the NVR. See Figure 1
on page 5.
2. Turn on the unit using the power switch on the back panel.
3. Select the preferred language for the system from the dropdown list and then
click Next .
4. Enable or disable the option to start the wizard automatically when the NVR is
turned on. Click Next .
5. Administrator configuration:
Navigate to the Admin Password edit box and click the edit box with the
mouse, or press Enter on the front panel or remote control, to display the
virtual keyboard. Enter the default admin password, 1234.
Note: You must enter an admin password. To change the Admin password,
check New Admin password and enter the new password and confirm it.
Caution: It is strongly recommended that you change the password of the
administrator. Do not leave 1234 as the default password. Write it down in a
safe place so that you do not forget it.
If you should forget the password to your NVR, contact your supplier with the
serial number of your NVR to obtain a secure code to reset your NVR.
If you wish to limit the admin rights to only one computer, enter the MAC
address of the user’s computer. Otherwise leave the MAC address
unchanged.
Click Next .
6. Time and date configuration:
Select the desired time zone, date format, system time and system date.
Note: Daylight savings time (DST) cannot be configured from the Wizard. See
“Configuring time and date” on page 38 for more information on DST.