Interlogix NVR 50 User Manual - Manual (Page 26)

3BChapter 4: Operating instructions
20 TruVision NVR 50 User Manual
Connect the mouse to the TVN 50 by plugging the mouse USB connector into
the USB port on the front or back panel. The mouse is immediately operational
and the pointer should appear.
Note: Use a USB 1.1 or higher mouse.
Move the pointer to a command, option, or button on a screen. Click the left
mouse button to enter or confirm a selection.
You can purchase a spare mouse by ordering part number TVR-MOUSE-1
mouse.
See Table 3 below for a description of the mouse buttons.
Table 3: Mouse buttons
Item Description
Left button Single-Click Live view: Select a camera to display the quick
access toolbar (see “Accessing frequently used
commands” on page 31).
Menu: Select a component of a menu, such as a
button or an input field. This is similar to pressing the
Enter button on the remote/front panel controls.
Double-Click Live view: Switch between single screen and multi-
screen mode in live/ playback mode.
Click and Drag Live view: Drag channel/time bar.
PTZ control: Adjust pan, tilt and zoom.
Tamperproof, privacy masking and motion
detection functions: Select the target area.
Digital zoom-in: Drag and select target area.
Right button Single-Click Live view: Display menu.
Menu: Exit the current menu and return to higher
level.
Scroll-wheel Scroll Up Live view: Return to the previous screen.
Menu: Move the selection to the previous item.
Scroll Down Live view: Move to the next screen.
Menu: Move the selection to the next item.
Using the IR remote control
The TVN 50 is supplied with an infra red (IR) remote control unit. Like the mouse,
it can be used to operate all of the main functions of the TVN 50.
The IR remote control can be programmed with a unique device ID address so
that the controller will only be able to communicate with NVRs with that address.
No programming is necessary if using a single TVN 50.
The device ID address only applies when using a remote control and not when
using a keypad.