Interlogix NX-1710E - Manual (Page 10)

NX-1710E Single Door Control 10
A DDING M ULTIPLE U SERS WITH A UTO -I NCREMENT
[
CANCEL
]
Accesses Activation mode
[
3-digit user number
]
Example: if 4-digit user code
or if 6-digit
If a valid user number is entered, LED1
(Green) on any enabled readers will begin
to flash.
Scan the card designated for the user
entered in the previous step. If the user card is not already in the
system, it will be added and mapped to
the entered user number and LED1
(Green) will continue flashing indicating
that the next user card can be scanned for
the next user number.
If the card is already in the system, the
reader will triple beep and LED1 (Green)
will continue flashing; the user number is
not incremented in this case.
Continue scanning user cards until the
desired number of cards has been added. After about 30 seconds without a card being
scanned, all the readers in the system will
be updated with the new user card
information.
IMPORTANT NOTE
Activating / De-activating / Resetting Users -- If User Number 0 is entered, the desired
function will be performed on the user associated with the card scanned.
A CTIVATE O NE U SER (S INGLE U SER )
[
CHIME
]
Accesses Activation mode
[
3-digit user number
]
Example: if 4-digit user code or
if 6-digit
If a valid user number is entered, LED1
(Green) on any enabled readers will begin
to flash.
Scan any card. The card information for the user entered
in the previous step will be activated, and
LED1 (Green) will stop flashing. After
about 30 seconds, all the readers in the
system will be updated.
D E -A CTIVATE O NE U SER
[
BYPASS
] Accesses De-activation mode
[
3-digit user number
]
Example: if 4-digit user code
or if 6-digit
If a valid user number is entered, LED1
(Green) on any enabled readers will begin
to flash.
Scan any card The card information for the user entered
in the previous step will be cleared, and
LED1 (Green) will stop flashing. After
about 30 seconds, all the readers in the
system will be updated.