Interlogix TruPortal - Manual (Page 121)

TruPortal Software User Guide 109
Configuring IP-Based Single Door Controllers
•
If an installation requires that an IPSDC and its corresponding host communicate through a
firewall, use the ICT to configure the IPSDC firewall to allow connections through port 3001.
•
Disable or bypass any network proxies while using the ICT.
•
After configuration is complete, the ICT can be disabled to prevent unauthorized access. See
Enabling and Disabling the ICT on page 110.
•
If options are changed on an ICT form, click Save at the bottom of the form to save changes
before switching to another form. This action saves the latest changes to a temporary
configuration file.
•
After completing all the forms, click Apply Changes and then click Restart Application for the
changes to take effect. Changes will be saved to the configuration database on the IPSDC.
The following table describes the buttons available in the ICT interface:
Using the ICT to Configure IPSDCs
Follow these steps to configure an IPSDC to recognize the IP address of the System Controller. These
steps can also be used to reconfigure an IPSDC if the IP address of the System Controller changes.
1. Use one of the following Internet browsers to open a browser window on the client workstation:
•
Microsoft Internet Explorer 7.0 or later
•
Netscape 7.0 or later
•
Mozilla Firefox 12.0 or later
2. In the browser Address field, enter the IP address of the IPSDC.
The factory default IP address of an IPSDC is 192.168.6.6. If you are not sure what the IP
address of an IPSDC is, press and hold the Restore Defaults button (SW7) on the IPSDC for at
least 5 seconds to restore its settings to factory default values.
3. When the ICT starts, type the User ID and Password for the ICT.
The default values are install and install.
4. Click [Login].
Button Usage Result
Save After changing values
on any form Saves changes to a temporary configuration file.
Apply
Changes After all changes are
complete Saves changes from the temporary configuration file to
the configuration database.
Restart
Application After selecting Apply
Changes The ICT picks up the latest changes from the
configuration database and starts again.
Restart
Controller After selecting Apply
Changes The IPSDC applies the latest changes and starts again.
Factory
Defaults a
a. If the default network parameters are restored using the SW7 button, then all parameters (including the IP
address of the IPSDC) will be modified.
To restore IPSDC
default settings IPSDC settings are restored to factory defaults. The IP
address settings are retained.
Change User/
Password To set the user ID
and/or password for
logging into the ICT. Changes the user ID and/or password for the ICT. The
default values are install, install. For increased
security, change the default values.