Interlogix TruPortal - Manual (Page 93)

TruPortal Software User Guide 81
Controlling Doors
3. Select Reinstate All Doors .
A Reader Reinstated event will be generated for each reader that was previously in the Locked Out
state, along with a single All Doors Reinstated event for the System Controller. A Reader in Card
Only Mode event or a Reader in Card + PIN Mode event is also generated for every door, depending
on how the reader is configured on the System Administration > Devices page.
Lock Out All Doors
Use the Lockout All Doors command to lock all doors and change the reader modes to prevent any
credentials from being granted access at the doors. Any actions that could impact the door strike will
not have any effect until a global Reinstate All Doors command is executed.
1. Select Monitoring > Doors.
2. Click the Global Door Commands action button at the top of the page.
3. Select Lockout All Doors .
A “Reader Locked Out” event will be generated for each reader that was not already in the Locked
Out state, along with a single “All Doors Locked Out” event for the System Controller.
Note: If all doors are locked out when a new door controller is added, the new door controller
will remain unlocked. To be locked out, all doors must be reinstated, then all doors
locked out again.
Unlock All Doors
Use the Unlock All Doors command to override security for the whole site, allowing anyone to exit or
enter without presenting a valid credential. Any actions that could impact the door strike will not have
any effect until a global Reinstate All Doors command is executed.
1. Select Monitoring > Doors.
2. Click the Global Door Commands action button at the top of the page.
3. Select Unlock All Doors .
A “Reader Reinstated” event will be generated for each reader that was locked out, along with a
single “All Doors Unlocked” event for the System Controller.
Door Command Menus
Sometimes it is necessary to override normal scheduled behavior for a specific door (for example, if a
door needs to be opened for a package delivery person), or for the entire site (for example, during a
fire drill). If some disaster or emergency situation occurred near the facility, all doors may need to be
locked out. Individual doors can be controlled from the Event View tab of the Monitoring > Doors
page. The global door commands allow users to change the state of all doors on the site with one
click.
Global Door Commands Menu
Note: After unlocking all doors or locking out all doors, use the Reinstate All Doors
command before trying to control any door individually.