Philips STU909 - Manual (Page 11)

Configuration
Installation
Calling up the CONFIGURATION menu
O Press key MENU
\> The MAIN MENU menu appears on the screen
O Select INSTALLATION
> The INSTALLATION menu appears on the screen
1> Lamp ON flashes green
O Press 2
> The CONFIGURATION menu appears on the screen.
INSTALLATION
1 MENU LANGUAGE
2CONRGURATION
3 SELECT SATELLITE POSmONS
4 SELECT PROGRAMMES
5 TXT PREFERENCE PAGES
6 SET CLOCK
select: 1 - 6, off
CONFIGURATION
1 ANTENNA POSITIONER
2 WIDE SCREEN TV SET (16:9)
3 NUMBER OP DISH ANTENNAE
4 CONRGURATION ANTENNA 1
5 CONHOURATION ANTENNA 2
6 OVERALL POLARIZER SETTINGS
7 SET EAST AND WEST UNITS
>NO<
>NO<
> 1 <
Automatic Antenna Positioner
O Press 1 and select the situation which applies to you with - or +.
D> NO if you have one or two 'fixed' dishes.
D> YES if you have a rotatable dish and an antenna positioner.
Note:
The STU 909 is designed to work together with an automatic antenna positioner
(i.e. see 209).
If you use a different antenna positioner, a message will be displayed after
each satellite change.
Wide-Screen TV (16:9)
O Press 2 and select the situation which applies to you with - or +.
> NO, if you have a TV with a normal screen (4:3).
> YES, if you have a wide-screen TV (16:9).
Number of dish antennae
O Press 3 and select the number of dish antennae you have with - or +.
I> 1, if you have one dish antenna.
I> 2, if you have two dish antennae.
Configuration Antenna 1
For the dish connected to INPUT 1:
O Press 4.
> The CONFIGURATION ANTENNA 1 menu appears on the screen.
Polarizer type
Signals from a satellite are transmitted with different polarizations.
There are 4 kinds of polarization: horizontal and vertical linear polarization and
left and right hand circular polarization.
For proper reception, you need a device called a polarizer which is located in
the LNC assembly of your dish antenna. This must be connected to the
polarizer socket at the back panel of your Satellite Tuner so that the right
polarization is selected automatically each time you change channels.
LNC (Low Noise Converter)
An LNC is the signal - receiving element in your satellite dish. The tuner has to
know which type of LNC is connected.
O From 1-3 select the type corresponding to your configuration
Note:
If you have a DUAL BAND LNC or the LNC is not powered by the satellite
tuner, option 3 a 14 V/18 Vpolariser is not available.
O Press MENU.
select: 1 - 7, -, +
(■
CONFIGURATION ANTENNA 1
1 POLARIZER TYPE > MAGNETIC <
2 LNC POWERED BY TUNER >YES<
3 DUAL BAND LNC
>NO<
select; 1 - 3, «, -t-
11