Philips STU909 - Manual (Page 18)

Installation of Satellite
Programmes
O
>
This section describes how to select and store new satellite programmes, and
how existing programmes can be changed or deleted.
The STD 909 can receive D2-MAC as well as PAL satellite signals. Generally
the system selection is performed automatically. The 'Sound preference’
menus are different for D2-MAC and PAL.
Note:
In the INSTALL mode it is always possible to remove the menus temporarily
from the screen:
O Press the Q) key on the remote control.
> The menu disappears temorarily from the screen (3 sec).
O Press key MENU
> The MAIN MENU menu appears on the screen
O Select INSTALLATION
l> The INSTALLATION menu appears on the screen
1> Lamp ON flashes green
Note:
It is assumed that the dishes and satellites are installed and that you have
selected the correct satellite antenna input 1 or 2 under SELECT SATELLITE
POSITIONS. If not, first follow the instructions in sections 6, 7, 8 and 9.
O Press 4.
C> The PROGRAMMES menu appears on the screen.
With this menu on the screen you can select all installed satellites with the
help of the <— Î
—> keys on your remote control (only for two dish
antennae or rotatable dish).
With the help of the Pv^\ keys on the remote control, you can select all the
programmes from the selected satellite.
O Press 1.
> The FIND PROGRAMMES menu appears on the screen.
O Press 1 and using - or + select the LNC band used:
I - Low band (14 V).
II- High band (18 V)
Note:
Band selection is only possible when a Dual-band LNC is present and
selected in the configuration menu. (See section 6)
O Press 2 (or 1 if dual-band LNC is ‘NO’).
I> The POLARIZER SETTINGS menu appears on the screen.
O Select the polarisation required by pressing 1 to 4.
O Fine-tune (skew) the polarisation using - or +.
I> The signal strength indicator helps your to find the maximum signal strength.
O Press MENU.
INSTALLATION
1 MENU LANGUAOE
2 CONFIGURATION
3 SELECT SATELLITE POSITIONS
4 SELECT PROGRAMMES
5 TXT PREFERENCE PAGES
6 SETCLOCK
select: 1 « 6, off
PROGRAMMES
1 FIND PROGRAMMES
2 PROGRAMME LIST
3 SOUND PREFERENCE
4 STORE
select: 1 >4, menu, off
FIND PROGRAMMES
1 LNC FREQ. BAND ^
2 POLARIZATION SETTINGS
3 SEARCH 1 055 GHZ
4 DIRECT FREQUENCY ENTRY
5 SYSTEM
>02MAC<
6 DESCRAMBLER SETTINGS
select: 1 » 6, +. menu, oil
POLARIZER SETTINGS
S1GNALSTENGTH;212
POLARIZAnON : 53
-_________ 0
1 HORIZONTAL
2 VERTICAL
SLEPT HAND CIRCULAR
4 RIGHT HAND CIRCUUR
select: 1 • 4, ♦, menu, off
Note:
In case you are using a magnetic polarizer, you might need to adjust the
polarizer settings (‘skew’) for each programme,
or:
In case you have a 14V/18V polarizer:
Select HORIZONTAL or VERTICAL by using - or +.
Search:
Press 3 (or 2 if dual-band LNC is ‘NO’).
An automatic search is performed and the scan stops automatically at the first
detected programme.
POLARIZATION
POLARIZATION >HORlZONTAL<
+ , menu . off
18