Philips STU909 - Manual (Page 12)

Configuration Antenna 2
O Follow the same procedure for the dish connected to INPUT 2 as described
under CONFIGURATION ANTENNA 1.
Adjusting the polarizer settings
The polarizer settings are pre-programmed at the factory. However, due to
local conditions, it might be necessary to deviate from these settings.
The overall Polarizer Adjustment menu enables you possiblility to change the
polarizer settings for all satellite programmes in one go.
This menu is displayed only if the pulse or magnetic polarizer is selected in
the CONFIGURATION ANTENNA menu.
The STU 909 allows you as well to programme the polarizer setting for each
satellite programme individually (fine tune: SKEW) - see section 10.
CONFIGURATION ANTENNA 2
1 POLARIZER TYPE > MAGNETIC <
2 LNC POWERED BY TUNER ■»YES<
3 DUAL BAND LNC
>NC*<
select:
O Press 6
l> The OVERALL POLARIZER SETTINGS menu appears on the screen.
O Select by pressing 1 , 2 , 3 or 4 the polarisation as indicated in the OSD
information at top left.
The highest signal strength, and best picture and sound quality, are selected
by pressing - or +.
Note:
Using programme av you can select programmes transmitted in other
polarizations.
Using < —i —> you can select another satellite if required.
O Press MENU.
Rotation limit (East-West)
Note:
Only available if an automatic antenna positioner (i.e. SCO 209) is connected.
To align the dish and set satellite positions, please refer to the instruction
manual of the antenna positioner.
OVERALL POLARIZER SETTINGS
SIGNAL STRENGTH 1212
POLARIZATION 53
1 HORIZONTAL
2 VERTICAL
3 LEFT HAND CIRCULAR
4 RIGHT HAND CIRCULAR
select; 1 • 4. % +. menu, off
12