Contec SPI-8450-LLVA - Manual (Page 101)

CHAPTER 8 - BIOS Setup
94
SPI-8450-LLVA
Description Choice
IDE HDD Block mode
Block mode is also called block transfer,
multiple commands, or multiple sector
read/write. If your IDE hard drive supports
block mode (most new drives do), select
Enabled for automatic detection of the optimal
number of block read/writes per sector the
drive can support.
Onboard FDC Controller
Select Enabled if your system has a floppy
disk controller (FDC) installed on the system
board and you wish to use it. If you install
and-in FDC or the system has no floppy drive,
select Disabled in this field.
Onboard Serial Port 1
Select a logical COM port name and matching
address for the first and second serial ports.
Select an address and corresponding interrupt
for the first and second serial ports.
Onboard Serial Port 2
Select a logical COM port name and matching
address for the first and second serial ports.
Select an address and corresponding interrupt
for the first and second serial ports.
UART 2 Mode
Available modes apply to selected serial port.