Contec SPI-8450-LLVA User Manual
Page 47
CHAPTER 6 - RAID Controller
40
SPI-8450-LLVA
6.1.2 Creating a Security Array with new drives
NOTE: Raid controller permit only two drives to be used for a single Mirrored array in Auto
Setup.
To create an array for data protection using new hard drives, follow these steps:
1.
Using the Spacebar, choose “Security” under the Optimize Array for section.
2.
Press <Ctrl-Y> keys to Save your selection.
3.
The window below will appear.
Do you want the disk image to be duplicated to another? (Yes/No)
Y - Create and Duplicate
N - Create Only
4.
Press “N” for the Create Only option.
5.
A window will appear almost immediately confirming that your Security array has been
created. Press any key to reboot the system
Array has been created.
<Press Any Key to Reboot>
6.
Proceed with normal FDISK and format procedures as if you had just installed a new hard
drive.
7.
Once the arrayed drives have been formatted, proceed to the Installing Driver your
operating system.