Carrier RTU OPEN 11-808-427-01 User Manual
Carrier Conditioners
Advertising
Table of contents
Document Outline
- Introduction
- Installation
- Field-supplied hardware
- To mount the RTU Open
- To wire the controller for power
- To set the RTU Open's address
- To set the RTU Open's communications protocol and baud rate
- Wiring the RTU Open to the MS/TP network
- Wiring inputs and outputs
- Wiring sensors to inputs
- Field-supplied sensor hardware
- Wiring an SPT sensor
- Wiring a Supply Air Temperature sensor
- Wiring a Duct Air Temperature sensor
- Wiring an Outdoor Air Temperature sensor
- Wiring a CO2 sensor
- Wiring an Outdoor Air Quality sensor
- Wiring a Relative Humidity sensor
- Wiring a Humidistat
- Wiring an enthalpy switch
- Wiring a status switch
- Wiring a compressor safety
- Wiring an occupancy switch or door contact
- Start-up
- Sequence of Operation
- Occupancy
- Supply fan
- Cooling
- Economizer
- Power Exhaust
- Unoccupied Free Cooling
- Optimal Start
- Enthalpy control
- Indoor Air CO2
- Heating
- Heat Pump operation
- Dehumidification
- Demand Limiting
- Door contact
- Remote occupancy
- Fire Shutdown
- Compressor Safety
- Fan Status
- Filter status
- Alarms
- Linkage
- Linkage Air Source Modes
- Troubleshooting
- Compliance
- Appendix A: RTU Open Points/Properties
- Appendix B: Single Point Linkage and Device Address Binding
- Index