Kenton Control Freak all versions - Manual (Page 22)

RX/TX Dump operations
SysEx RX prog map
This allows you to redirect incoming profile dumps to any internal program.
Pressing the [––>] button will move to the next screen:
The Data Wheel can be used to select a destination program for the incoming
profile.Then just send the data to the Freak from your computer.
Note: this function is only active while this screen is displayed.
SysEx dump single
This allows you to dump individual slider, button or F key information to an
external SysEx storage device.
Pressing the [––>] button will move to the first screen:
The Data Wheel can be used to change the source program if required.
The bottom line of the display will show the name of the selected slider,
button or F key.
Pressing the [––>] button will move the cursor across to the right.
The initial setting sldr x can be changed with the top left three buttons in
combination with [SHIFT] and the Data Wheel to select any slider, button or
F key.
F1 F2 F3
Without [SHIFT] Slider Button On F key On
With [SHIFT] Slider Button Off F key Off
The bottom line of the display will show the name of the selected slider,
button or F key.
Pressing the [––>] button will move to the next screen:
Pressing [STORE] will dump the chosen data from MIDI Out.
SysEx dump prog
This allows you to dump individual programs to an external storage device.
Pressing the [––>] button will move to the next screen:
The Data Wheel can be used to select the required program.
Pressing the [––>] button will move to the next screen:
Pressing [STORE] will dump the chosen data from MIDI Out.
EDIT MENU 17
EDIT MENU 16
EDIT MENU 15
EDIT MENUS CONTROL FREAK
18
SYSX`RX`PROG`MAP
Push`>`to`Select
ReMap`to`Prog``0
``Program`Name``
SYSX`DUMP`SINGLE
Push`>`to`Select
Fm`Prg``_`Sldr`1 ```````14```````
``Slider`name```
Fm`Prg````Sldr`_ ```````14``````7
``Slider`name```
`Push`STORE`Key`
to`Send`Syx`Dump
SYSEX`DUMP`PROG`
Push`>`to`Select
From`Program``36
`Push STORE`Key`
to`send`Syx`Dump
```````````````_
``Program`Name``