Kenton Control Freak all versions - Manual (Page 40)

Setting a button to act as a sustain pedal
This is most useful if this button is then assigned to an external switch pedal.
Select ‘Edit PB On Name’– screen reads EDIT`PB`ON`NAME
Use the Data Wheel to select a button and give the button a name in the usual way (eg:‘Sustain On’)
Hold [SHIFT] and press [STORE] – this takes you directly to: ``Header`Data
Minimum`Level``0
Press the [––>] button twice – screen reads: `Header`Data
`Button`ON`only
Use the Data Wheel to select ‘Button On + Off’ Button On + Off
Press the [––>] button – screen reads: ````Command
``End`of`Data
Use the Data Wheel to select: ```Controller
Press the [––>] button – screen reads: 0``Bank`Select
Use the Data Wheel to select: 64`Sustain`Pedal
Press the [––>] button – screen reads: Controller`Value
Data`Val`00h```0
Use the Data Wheel to select: Data`Val`7Fh`127
Press the [STORE] key to save your data: UPDATING`MEMORY
Use the Data Wheel to select: Edit PB Off Name
Use the Data Wheel to select the same button as before and edit the name in the usual way (eg:‘Sustain Off’)
Hold [SHIFT] and press [STORE] – this takes you directly to: ``Header``Data
Minimum`Levl```0
Press the [––>] button twice – screen reads Header`Data
Button`ON`only
Use the Data Wheel to select: Button`On`+`Off
Press the [––>] button – screen reads: ````Command
``End`of`Data
Use the Data Wheel to select: ```Controller
Press the [––>] button – screen reads: 0``Bank`Select
Use the Data Wheel to select: 64`Sustain`Pedal
Press the [––>] button – screen reads Controller`Value
Leave this setting as it is Data`Val`00h```0
Press the [STORE] key to save your data UPDATING`MEMORY
EXTERNAL INPUTS 1 & 2 CONTROL FREAK
36