Kenton Control Freak all versions User Manual
Page 32
Turn the Data Wheel to the right (clockwise) until the display shows:
Data`Val`40h``64
Press the [––>] key – the display will show:
````Velocity````
Data`Val`00h```0
Turn the Data Wheel one click to to the left - the display will show:
Data`from`Slider
Press the [––>] key – the display will show:
````COMMAND
``End`of`DATA
Turn the Data Wheel four clicks to the right and the display will show:
Note-Off
Press the [––>] key – the display will show:
Note`Number
Data`Val`00h```0
Turn the Data Wheel to the right (clockwise) until the display shows:
Data Val 43h 67
Press the [––>] key – the display will show:
``Velocity`````
Data`Val`00h```0
Turn the Data Wheel one click to to the left - the display will show:
Data`from`Slider
Press the [––>] key – the display will show:
````COMMAND
``End`of`DATA
Press the [STORE] key to save your data
Press the [EXIT] key to go back to
PLAY MODE
To use this example, first select a velocity by using the slider – this is shown in the display. 64 is a
good number to start with. Note that a velocity of zero is treated as a note-off so if you have the
slider at the bottom of its travel, you will not hear anything. Press the button and a chord will be
sent, release the button and the notes will be released.
Shortcut: after you have programmed the PB On data, you could simply copy the PB On data to the
PB Off data for the same button and change the notes on to notes off.
EDITING EXAMPLES
CONTROL FREAK
28