Maxim Integrated High-Speed Microcontroller Users Guide: Network Microcontroller Supplement - Manual (Page 221)

High-Speed Microcontroller User’s
Guide: Network Microcontroller
Supplement
REVISION
NUMBER
REVISION
DATE
SECTION
NUMBER
DESCRIPTION
PAGES
CHANGED
0 12/02 — Initial release. —
1 1/9/03 6 Replaced Figure 6-5. 90
2 3/5/03 11 New paragraph added to the Divide-by-13 Option section to explain the options’ usefulness. 107
4
CAN 0 Status Register (C0S), Bit 6 (EC96/128): Description corrected to: "EC96/128 = 0 indicated
that the current transmit error counter and receive error counter both have an error count of less
than 97." (previously 96)
37
CAN 0 Standard Global Mask Register 1 (C0SGM1): Last sentence clarified to show that "A read
of these bits will return a 0, writes are ignored."
126
CAN 0 Message Center y Arbitration Register 3 (C0MyAR3): The second sentence for the
Reserved bits was clarified to read "These bits can be modified by the application software."
129
3 11/12/03
19
Second paragraph in the Receiving/Responding to Remote Frame Requests section was moved to
end of Transmitting Remote Frame Requests section for clarification.
139
4 2/5/04 23
Asynchronous TCP/IP Maintenance Functions section: Correction for wos_crit_count (in
entercritsection and leavecritsection). Located at address 68h, not 6Bh.
195
5 2/18/04 23 Serial Loader section: Second sentence changed to reflect that an external reset (RST = 1). 173
Added information on DS80C410/DS80C411. Various pages
6 4/13/05 —
Changed name of document to Network Microcontroller Supplement. All
7 10/05 20
Normalize section: Added sentence to description saying the normalize function can only be used
on nonzero values.
173
4 Corrected typo for TMOD bit 2 description. 31
19 Updated Figure 19-11 and moved it to page 168. 168 8 8/06
23 Added crystal speeds to Autobaud-Rate Detection section. 195
9 7/07 4 Corrected description of P5CNT SFR to reflect its presence on the DS80C411. 47
10 10/07 4
Corrected typos; added description to MCON1.7 and MCON1.6 defining that the bit is undefined
on the DS80C400.
25, 85
11 3/08 23 Added CRC-16 polynomial to Command Summary C begin address. 195
12 9/08 6 Replaced Figure 6-10 (incorrect figure inserted in error.) 107
REVISION HISTORY
221 Maxim Integrated 160 Rio Robles, San Jose, CA 95134 USA 1-408-601-1000
Maxim cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim product. No circuit patent licenses are implied.
Maxim reserves the right to change the circuitry and specifications without notice at any time. The parametric values (min and max limits) shown in the Electrical
Characteristics table are guaranteed. Other parametric values quoted in this data sheet are provided for guidance.
©  Maxim Integrated The Maxim logo and Maxim Integrated are trademarks of Maxim Integrated Products, Inc.