Compaq 230934-002 - Manual (Page 141)

Command Line Interface
C-34 Modular SAN Array Fabric Switch 6 User Guide
COMPAQ CONFIDENTIAL
Writer: Kim L. Miller File Name: h-appc Command Line Interface.doc
Codename: Millebourne Part Number: 230934-002 Last Saved On: 8/7/02 9:39 AM
Variables Description
ip_address,port number
ip_address The IP address of the SNMP trap recipient that you
want to create a filter for
port_number The port number of the SNMP trap recipient that
you want to create a filter for
trap_type
EMer Filters for traps of the type “Emergency”. Highest
level of severity
Alert Filters for traps of the type “Alert”.
Crit Filters for traps of the type “Critical”.
ERr Filters for traps of the type “Error”.
Warn Filters for traps of the type “Warn”.
Notify Filters for traps of the type “Notify”.
Info Filters for traps of the type “Info”.
Debug Filters for traps of the type “Debug”.
Mark Filters for traps of the type “Mark”. Lowest level of
severity.
Traps State = <ip_address,port_number> = <trap_state> — This
command is used to set the state of a particular SNMP trap recipient as active or
inactive. The command variables are defined as follows: