Compaq 230934-002 - Manual (Page 93)

MSA Fabric Switch 6 Management Utility
3-58 Modular SAN Array Fabric Switch 6 User Guide
COMPAQ CONFIDENTIAL
Writer: Kim L. Miller File Name: d-ch3 MSA Fabric Switch 6 Management Utility.doc
Codename: Millebourne Part Number: 230934-002 Last Saved On: 7/17/02 7:52 AM
Assigning Zone Members to Zones
To add the Zone Members to the desired Zones, select the desired Zone Member and
use the drag-and-drop technique to add it to the desired Zone.
Assigning Zones to Zone Sets
To add the Zones to the desired Zone Set, select the desired Zone and use the
drag-and-drop technique to add it to the desired Zone Set.
Activating the Zone Set
To activate and apply the Zone Set:
1. Right-click the desired Zone Set and select Activate.
The active Zone Set is shown in bold on the screen.
2. Click Apply.
The selected Zone Set is now the active Zone Set used by the switch.
Example Zoning Configuration
Assume the following:
• Server1 needs to access Disk1 exclusively for Operating System boot (OS Boot).
• Server1 needs to access Raid1 for shared storage.
• Server1 needs to access Tape1 for backup.
• Server2 needs to access Disk2 exclusively for Operating System boot.
• Server2 needs to access Raid1 for shared storage.
• Server2 needs to access Tape1 for backup.
Before you begin to configure your zoning, you must first define the zone members,
zones, and zone sets that you will need.
Table 3 lists the zone members, zones, and zone sets being used in this example and
indicates what members the zones and the zone sets contain.