Setup > basic, Advanced configuration with the web-based utility, Video format – Cisco WVC80N User Manual
Page 15: Device settings, Network settings, Wireless settings
Advanced Configuration with the Web-based Utility
Wireless-N Internet Home Monitoring Camera
To select the video format, click the Video Format button,
and the Video Format window appears. Select either
MPEG-4 or MJPEG, then click Save. To exit without saving,
click the X in the upper-right corner of the window.
Video Format Button
Video Format Window
Setup > Basic
The Setup > Basic screen appears when you click the Setup
tab or Advanced Configuration on the Welcome screen.
The Setup > Basic screen allows you to alter the Camera’s
Device settings, Network settings, Wireless settings, and
Setup > Basic
Edit the settings on this screen as needed. Then, to save
your changes, click Apply. To cancel any unsaved changes,
click Cancel. To get additional information about the
screen’s features, click Help.
You may assign the Camera any name
up to 15 characters long. Unique, memorable names
are helpful, especially if you use multiple Cameras on
the same wireless network.
Enter information about the Camera in
this field. You can enter up to 32 characters.
This feature allows you to enable or
disable the Camera’s LED.
This displays the Camera’s current
date and time. If it is incorrect, click Sync with PC to
use your computer’s date and time.
Select the time zone for the Camera’s
Adjust for Daylight Saving Time
Select this to adjust
the Camera’s current time for Daylight Saving Time.
You must deselect this option when
Daylight Saving Time ends.
To configure the Camera’s network settings, select the
protocol you wish to use from the dropdown menu: IPv4
only, IPv6 only, or IPv4 and IPv6. The default is IPv4
If you want to automatically
assign the Camera an IP address from a DHCP server,
then select Obtain Address Automatically (DHCP)
(default). If you want to assign the Camera a static IP
address, then select Fixed IP Address, and complete
the IP Address, Subnet Mask, Gateway, Primary DNS and
Secondary DNS fields.
Address, Subnet Mask, Subnet prefix length
(IPv6 only), Gateway, Primary DNS, Secondary
Complete these fields if you want to assign the
Camera a static IP address. You need to enter at least
one DNS address.
Enter the network’s SSID or network name here.
Select the network’s mode, Ad-hoc or
If the Camera is set to Ad-hoc mode,
select its channel setting from the drop-down menu.
Click Edit Security Settings to display the
Wireless Security screen.
Setup > Basic > Wireless Security
The Wireless Security screen is used to configure the
Camera’s wireless security settings to match your wireless
network settings. The settings are as follows.
Select the wireless security mode used
by your wireless network:
Disable (no wireless security)
The method selected determines which other fields are
displayed on the screen. The different security modes