NORAC UC5-BC-ECHO-VT - Manual (Page 14)

10
In manual mode, the height displayed under each boom section is measured from the spray
nozzles to the soil (Soil Mode) or crop canopy (Crop Mode or Hybrid Mode). If there are five
height sensors on the sprayer, the height displayed is the average for each boom section. The
crop at the bottom of the screen indicates the mode the controller is in. If the green line is
above the crop, the system is in Crop Mode or Hybrid Mode. If the green line is below the
crop, the system is in Soil Mode.
The following applies to Virtual Terminal only:
When two or more virtual terminals are connected on the Display Bus, the Move to Next VT
button will appear on the Soft key area of the Run screen. This button allows the user to select
the preferred terminal on which to display the UC5 screen. By pressing this button the UC5
screen will move to next available terminal.
6.3 Settings
To change the NORAC UC5™ settings, select the Settings button as shown in Figure 6. The
Settings can be accessed at any time, regardless of being Automatic or Manual Mode. The
second setting screen is accessed by selecting the Next button as shown in Figure 7. When
the system is in Manual Mode more settings and options are available by selecting the Next
button as shown in Figure 9. These settings are discussed in later sections. If the system is in
Automatic Mode, the “MANUAL” button is displayed to be able to put the system into Manual
Mode (Figure 8 and Figure 10) and to change other settings.
Figure 7: 1 st Settings Screen in Manual Mode Figure 8: 1 st Settings Screen in Automatic Mode
Figure 9: 2 nd Settings Screen in Manual Mode
with Learned Crop Height Checked
Figure 10: 2 nd Settings Screen in Automatic
Mode with Learned Crop Height Checked