NORAC UC5-BC-ECHO-VT - Manual (Page 27)

23
8.5 Manual Setup
The UC5™ Height Control system will not operate in Automatic Mode until the system has
been configured. It is recommended that the Automatic System Setup be used, but if necessary
a Manual System Setup may be used. The Manual Setup involves setting up each sensor, valve
output and remote switch input.
Figure 16: Manual Setup Buttons
8.5.1. Sensor Setup
Before beginning, it is necessary to know the serial number and
location for each of the sensors. The sensor serial number is located
on the bottom of the sensor housing, beside the foam disc.
It is recommended that you record the sensor location and serial
number in Figure 17, because this information may be required during
troubleshooting.
Figure 17: Sensor Serial Numbers and Positions
Sensor Setup Button
Remote Switch Setup
Button Valve Setup Button