NORAC UC5-BC-ECHO-VT - Manual (Page 23)

19
You will then be instructed to place your
booms so the nozzles are 35” (90cm) from
the ground. Adjust the distance from the
nozzle to the ground directly beneath.
Ensure you are over bare, flat soil.
When the measured distance is 35” (90cm)
select Check button.
You will then be instructed to hold the
Check button. Continue holding while each
boom section is moved.
The display will show an arrow. At this time
the boom will be in motion. When it is
done the display will instruct you to release
the Check button. Do not move the booms
at this time.
You will then be instructed to hold the
Check button. The terminal will display
“Cruising”.
The terminal will then instruct you to exit
the cab and pull the boom tip down towards
the ground, and then release the boom.
Ensure you stay a minimum of 3 feet (1m)
away from any of the sensors.
35”
90 cm