Reznor RDF Unit Installation Manual User Manual

Page 2

Advertising
background image

I-RDF, PN148384R5, Page 2

WARNING: On makeup air heaters which also recirculate room air, outside ventilation

air must be provided in accordance with the information shown on the heater

nameplate.

Recirculation of room air may be hazardous in the presence of:

(a) Flammable solids, liquids, and gases;

(b) Explosive materials; or

(c) Substances which may become toxic when exposed to heat.

WARNING: Improper installation, adjustment, alteration, service, or maintenance

can cause property damage, injury or death. Read the installation, operation,

and maintenance instructions thoroughly before installing or servicing this

equipment.

WARNING: Gas-fired appliances are not designed for use in hazardous

atmospheres containing flammable vapors or combustible dust, or atmospheres

containing chlorinated or halogenated hydrocarbons. See Hazard Levels

above.

1.0 General

1.1 Hazard Labels and Notices

There are warning labels on the unit and throughout this manual. For your safety, read

the definitions below and comply with all boxes labeled CAUTION, WARNING, and

DANGER during installation, operation, maintenance and service of this heater.

HAZARD INTENSITY LEVELS

1. DANGER: Failure to comply will result in severe personal injury or death

and/or property damage.

2. WARNING: Failure to comply could result in severe personal injury or

death and/or property damage.

3. CAUTION: Failure to comply could result in minor personal injury and/or

property damage.

Hazard Intensity

Levels Apply to

Warnings throughout

this Manual

1.0 General ..............................................2

1.1 Hazard Labels and Notices .......... 2
1.2 General Description .................... 3
1.3 Warranty ....................................... 3
1.4 Installation Codes/Requirements 3

2.0 Location .............................................4
3.0 Uncrating/ Preparation .....................4
4.0 Clearances and Dimensions ...........4

4.1 Clearances ................................... 4
4.2 Dimensions ................................. 5

5.0 Mounting ...........................................5

5.1 Weights ........................................ 6
5.2 Rigging ......................................... 6
5.3 Mounting on Field-Supplied

Supports ...................................... 6

5.4 Mounting on a Roof Curb ............. 6

6.0 Mechanical ........................................9

6.1 Gas Piping and Pressures ........... 9
6.2 Unit Inlet Air .................................11
6.3 Supply Air Discharge .................. 15
6.4 Blowers, Drives, and Motors ...... 16

7.0 Electrical Supply and Wiring .........17
8.0 Controls ...........................................19
9.0 Check-Test Start .............................22

Before Startup ................................. 22
Startup ............................................. 23
After Startup ..................................... 25

APPENDIX .............................................26

Technical Data ................................. 26

REFERENCES .......................................26

INDEX .....................................................27

INSTALLATION RECORD ....................28

TABLE OF CONTENTS

Advertising