Digital depth & battery indicators – Vexilar Flasher Family 2013 User Manual

Page 38

Advertising
background image

38

The DD-100 is Vexilar’s
first smart digital indicator
display that offers both
digital depth and a
battery indicator when
you push the “push to
test button.” The DD-100
will work on all Vexilar
FL series of flashers,
including older Hondex,
Si-tex and Micronar FL-8
models. Vexilar’s new DD-100 gives anglers
what they have been asking for, “Digital Depth!”
This indicator will become a standard piece on
all future Pro and Ultra Packs, but can also be
purchased as an added accessory.

The digital depth display will always give you a
depth reading as long as your Vexilar FL flasher is
turned on and the transducer is in the water. The
digital depth portion of the indicator will work
even if you’re not in the correct depth range. This
will allow you to get your flasher in the best depth
range possible. If your display is blinking or the depth numbers are going up or down rapidly, it could
be that you’re over a huge school of fish or baitfish OR the bottom is irregular.

The DD-100 was designed to fit in place of the popular D-130 or T-130 battery indicators which
Vexilar has been selling for years. You can easily outfit your Pro Pack, Ultra Pack or Genz Pack with
the DD-100. The DD-100 not only gives you digital depth, but also gives you the battery status by
pressing a button.

The only time you will see a battery status is when you push the “push to test button.” The battery
status is given in percentages of voltage remaining in the battery. For example, if you push the “push
to test button,” and it reads 70%, that means your battery is at 12.2 volts, 100% = 12.7 volts and
0%=11.0volts.

Current draw: 124uA (micro amps) when off and 21mA (milliamps) when on.
Note that this is not a charge indicator.

A unique battery fuel guage
that recognizes both the
discharge and charge
cycle of your battery. It will
sense the current charging
condition of the battery,
display the percentage of
remaining capacity and
display a charge trend arrow.
( or ).

The D-130 will continue to measure capacity and
trend as long as it is connected to the battery.
When an additional “load” is applied to the
battery, the capacity will decrease according to
the load applied.

Digital Depth & Battery Indicators

DD-100 FL Digital Depth Indicator

D-130 Digital Status Indicator

IMPORTANT

: Be sure the indicators are not on during long

storage periods, as excessive battery drain can result. For
Pro Pack systems, disconnect the indicator from the battery
before storage. For Ultra Pack systems, be sure the master
power switch is off. Battery failure due to deep discharge
is not covered under your warranty.

IMPORTANT

: Be sure the indicators are not on during long storage periods, as excessive

battery drain can result. For Pro Pack systems, disconnect the indicator from the battery
before storage. For Ultra Pack systems, be sure the master power switch is off. Battery
failure due to deep discharge is not covered under your warranty.

D-130

DD-100

Advertising
This manual is related to the following products: