Vexilar Flasher Family 2013 - Manual (Page 39)

39
Battery Charging
CHARGE AFTER EACH USE
1 Amp Digital Automatic Charger
(model V-410 / 1 Amp)
1 Allow the battery to warm up before charging. This makes it
easier for the charger to charge the battery and the battery is
more accepting of a charge.
2 Plug the charger into a wall outlet, verify that it is operating
by noting the illuminated GREEN light.
3. Connect the charger to the Easy Charge Jack attached to the
unit. The charger’s light will switch to RED, indicating that it is
connected correctly and the battery is charging.
If your charger is NOT equipped with an Easy Charge Jack, connect the
terminals to the battery with the RED (+) connected to positive and BLACK
connected to negative (–). The charger’s light will switch to RED, indicating
that it is connected correctly and the battery is charging.
FLASHING RED INDICATES A REVERSE CONNECTION .
4. Keep the charger plugged in and connected until the RED light has changed to
GREEN. This indicates the battery is at full charge.
5. Unplug the charger from the wall outlet and disconnect from the battery.
Charging times will vary depending on how much the battery has been drained. If the
battery has been completely drained (approx. 24 to 30 hrs. of use on a 9 amp battery)
the battery will require about 9 hours of charging. Once the battery is fully charged and
the charger’s light returns to GREEN, the charger is then operating in a “Maintenance
Mode”. At this stage, the charger can remain connected to the battery indefinitely and the
battery will be maintained at full charge.
ATTENTION PRO PACK OWNERS: Please remember to disconnect your battery from
the Pro Pack before summer storage. Failure to do so may drain your battery completely
over time, leaving it in a state of prolonged deep discharge. Battery failure that is NOT
covered under the warranty may result.
ATTENTION ULTRA PACK OWNERS: If you have an Ultra Pack system, be sure your
Master Power switch is ON and the flasher is turned OFF for charging,
DID YOU KNOW? There is no need to disconnect the flasher when charging, although it
should be switched off. Also, make sure the battery has a full charge and is disconnected
or that all power is switched off before putting it away for storage.
Remember to charge
after each use.
See page 61 for additional tips and warranty information.
Easy Charge Jack