Sears KENMORE 385. 17928 - Manual (Page 36)

■SECTiON'-~3. ■;: - le - ari ^ thestitc H' es
Straight Stitches (Continued)
• Sew in a Zipper
Fabric Preparation:
Put the top sides of the fabric together
and sew to the end of the zipper
opening. Use the reverse to lock the
a LI L^i lo
Sew the zipper opening with stitch
length at "4" and top thread tension
at “3".
End of opening
Top edge of fabric
Set the Machine
Stitch width
control 0
Top thread tension
Stitch length
control 2
-2.
Stretch Stitch
pu
E: Zipper
foot
The pin on the
right hand side ___________
,
The pin on the
left hand side
To attach the zipper foot:
• To sew on the left side of the zipper,
attach the presser bar to the right pins
on the zipper foot.
To sew on the right side of the zipper,
attach the presser bar to the left pins
on the zipper foot.
( 1 / 8 "
•c~
Zipper teeth
side r>(
liibrir
To Sew:
1. Reset stitch length at 2 and top
thread tension at 2 to 6.
Fold back the left seam allowance
as shown.
2. Turn under the right seam allow­
ance to form a 1/8" fold.
3. Place the zipper teeth next to the
1/8" fold and pin in place.
1
7.
laotton' .side
(]t fabric
Attach the presser bar to the right
pins on the zipper foot.
Lower the zipper foot on the top
side at the bottom of the zipper
so that the needle pierces the fold
and the zipper tape.
Sew through the fold and the
zipper tape to the point where the
slider begins.
Lower the needle to hold the
fabric and raise the presser foot.
34