Threading the bobbin case – SINGER 401A User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
n
V
THREADING THE BOBBIN CASE
(
Hold bobbin so that thread leads off, in direGtion shown. Place bobbin in case.
Lead thread into slot and under spring.
^
J
'
1
i t - i S i
\
WSSM«hy«Wi«<sw.»5
Draw thread into notch at end of spring, pulling off about 3 inches of thread
across the bpbbin.
Close slide plate allowing thread to enter notch.
Advertising