Button sewing foot, Thread shank – SINGER 401A User Manual
Page 68
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
50
BUTTON SEWING FOOT
Set Red Lever at 4. The needle should then
enter into the right hole of the button. Take
approximately six
zigzag
stitches in this position.
End on the left side.
To fasten stitching, adjust to number one
Red Lever setting and take approximately three
stitches.
THREAD SHANK
In order to form a shank, stitching is done
over a regular machine needle. Position button
and lower button foot. Place needle in the groove
of the foot so the point enters the hole.
A larger shank results when the heavy end of
the needle is utilized.
Advertising