SINGER 14U285B User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
• Needle Positions
Three needles can be inserted to the needle clamp on this
machine as shown in the sketch but only one or two
needles are to be used for sewing. Do not attempt to use
three needles.
A. Overedge right needle-
B. Overedge left needle—
C. Chainstitch needle_____________________________
-O
The Operator’s Guide refers to different needle positions by illustrating the needle clamp as shown in the
following examples:
Note: When both the left and right overedge needles arc inserted, the left needle will be slightly higher
than the right.
How to insert the needles
Use Singer needles Cat. No. 2054 available in sizes #14 and #10.
To remove the needles:
• Be sure the power line plug is disconnected from the wall socket.
• Turn the hand wheel over toward you until the needles are at their highest position. Loosen the
needle set screws with the small screwdriver and remove the needles.
To replace the needles:
• Insert the needles into the needle clamp as far as they will go with the flat surface to the rear
and firmly tighten the needle set screws.
Note: One screw holds in both the left and right overedge needles.