Preparation for sewing – SINGER 14U285B User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
4. Preparation for sewing
Connect the machine plug to the electrical receptacle of your machine and the power line plug to the wall
receptacle.
For 220/240V
Power switch
(used also for light switch)
Push upper side ("I" mark)
to turn "ON".
Push lower side ("O" mark) is visible
to turn "OFF..
For 120V
Power switch
(used also for light switch)
When the switch is ON,
the red mark on the knob
Power line plug
Wall receptacle
To run the machine and control the speed, press the speed controller. The harder you press, the faster the
machine will sew. To stop the machine from sewing, remove your foot from the speed controller.
Caution:
® Be
sure that
the electrical
voltage of
the socket outlet (wall receptacle) is the same as the rated
voltage
of the motor.
® Handle the foot
controller
with
care and
avoid dropping it on the floor. Be sure not to place
anything
on
top of it when
not in use.
® Disconnect the power-line plug
from
the
socket outlet when changing needles, presser feet or throat
plates,
or when leaving the machine
unattended.
This
eliminates the possibility of starting
the machine
by
accidentally
pressing
the speed
controller.
• Before cleaning your
machine,
disconnect the power-fine plug from the socket outlet.