SINGER W1717 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
push back to fold handle,
full out spool pin and put a felt
iin spool pin.
Rut a spool on spool pin.
Draw thread from spool pin
through thread guide and pre
tension device, following numb-
rs
(I;
and
(Z).
W
bo
Pu
'ind thread clockwise around
ibbin several times.
ish bobbin on to spindle.
Holding handwheel with your left
hand disengage handwheel by
unscrewing stop motion knob.
9
-
V
V
trouble
correction;
'6
y 1
Push bobbin to right and press
down foot controller.
Machine stops automatically
when bobbin is full.
Push bobbin to left, to disengage
from wheel.
Take off bobbin from spindle
and cut thread.
Retighten stop motion knob.
If bobbin is wound unevenly
as shown, open face cover and
loosen set-screw of the guide for
bobbin winding: Use screw driver
to adjust height.
1 n -