SINGER W1410 User Manual
Page 19
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Place spool on spool pin as shown, with
thread coming from the back of the
spool.
Draw thread through top thread- guides.
Holding spool stationary with right hand,
poll the end of the thread between the
tension discs as shown above (3).
Pull the end of,the thread taut with left
hand. This will pull the spring wire up
and past the end of the hook. The thread
will -then slip into the hook when the
spring is released as in (4) .
Release spool of thread and thread
machine throi^h take-up lever (
b
) and
thread guide @ as shown above. Thread
then passes through guides Q) and (S).
Thread needle (9) from front to rear.
THREADING THE NEEDLE
N
(D
^
\
...
J
-
16
-