SINGER 9100 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
Move bobbin winder switch to the left, remove
bobbin and retighten stop motion screw.
If bobbin does not wind evenly, loosen screw G which
holds tension bracket in position.
• Move bracket away from you if bobbin winds high
to the front.
• Move bracket toward you if bobbin winds high to the
back.
WHEN BOBBIN IS FULL
Tension
Spring
THREADING BOBBIN CASE
1.
Hold bobbin so that thread unwinds in the direction
as shown at left and place bobbin in the bobbin
case.
2.
Pull thread into
notch,
draw it under
tensionspring
and Into slot. Allow about 4 inches (10cm) of thread
to hang freely from bobbin case.
— 8 —
Advertising
This manual is related to the following products: