Performance checklist, Enjoy sewing – SINGER 9100 User Manual
Page 45
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
performance checklist
Remember To...
If Fabric Fails to Feed, Make Sure... If Thread Breaks, Make Sure...
Plug
machine
into
an
electrical
outlet.
Turn hand wheel toward you to
position needle and take-up lever.
Start and finish sewing with the
take-up lever in its highest position.
Test
stitch
on
a
fabric
sample
before starting a sewing job.
Replace
bent
or
burred
needles.
Lower presser foot before setting
pressure screw.
Tighten hand wheel knob and move
bobbin-winder
switch
to
left
after
winding a bobbin.
Presser foot is in down position.
Pressure
screw
is
adjusted
pro
perly for the weight and texture
of your fabric.
Stitch
length
selector
is
properly
set.
Hand wheel knob is securely tigh
tened.
Lint
has not accumulated around
feed.
Feed throw-out knob is turned to
left (regular stitchihg) position.
Machine
is
correctly
threaded.
Bobbin
case is
correctly
inser
ted and threaded.
Bobbin case area is free of lint and
loose thread ends.
Bobbin and bobbin case are not
damaged.
Needle
is
straight
and
securely
tightened in clamp.
Thread
is
suitable
for
size
of
needle.
Thread is free of slubs and knots.
Thread
is
unwinding
freely
from
spool.
Needle-thread tension is light enough.
Needle slot in plate and presser
foot are not damaged.
Enjoy Sewing!
-43-