SINGER 9100 User Manual

Page 8

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

NEEDLES AND THREAD

This machine uses needles Catalogue 2020 (15x 1),

available in sizes 9. 11, 14. 16 and 18.

For perfect stitching, select correct needle and thread

to correspond with fabric according to the table on page

5. Be sure to use like threads for both needle and

bobbin.

CHANGING THE NEEDLE

Raise needle bar to its highest point by turning the

hand wheel toward you. Loosen the needle clamp screw

and insert needle into clamp as far as it will go. with

the flat side of the needle to the right. Then tighten

needle clamp screw.

NEEDLE THREADING

1. Turn hand wheel toward you to raise take-up lever

to Its highest position.

2. Raise the presser foot.

3. Lead thread through all the threading points shown

at right and thread needle from left to right.

4 Draw about 4 inches of thread through eye of

needle

—6

Advertising
This manual is related to the following products: