SINGER 9100 User Manual
Page 39
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
With Embroidery Hoop
• Needle Position: Centre
• Stitch Width:0
• Stitch Length: In FINE Area (Above 20)
• Feed Throw-out Knob: To Right (Darning)
Position
• No Presser Foot
• Presser Bar Lowered
1.
Trim ragged edged from area to be darned
and centre worn section in embroidery hoop.
2.
Position work under needle; lower presser
bar to engage tension.
3.
Hold needle thread loosely with left hand,
turn hand wheel over and draw bobbin thread
up through fabric. Hold both thread ends and
lower needle into fabric.
4.
Outline area to be darned with running
stitches for reinforcement.
5.
Stitch across opening, moving hoop under
the needle at a slight angle from lower left
to
upper
right.
Keep
lines
of
stitching
closely spaced and even in length. When
opening
IS
filled, cover area with crosswise
lines of stitching.
This method of controlling fabric movement
with an embroidery hoop may be used to do
embroidering and monogramming.
-37—