Automatic operation of zig zag sewing – SINGER W761 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Automatic Operation of Zig Zag Sewing
Fig. 12
ii #
Fig. 11
Fig. 13
To lose« Decorator Disc
1. Turn restrictor knob ;B Fig. 11) till pointer on dial is
at "O".
2.
Press push button < Fig. 13) and cover of disc chamber
will pop open.
3.
Turn zig zag knob {A Fig. 11) so that pointer of dial
is at "4", and while holding it at this position, insert a
disc as in figure 13. Make sure that the disc is inserted
properly, by placing disc on spindle, and turning the disc
by
hand
until
the
notch
on
the
underside
of
disc
fits
over the small pin on spindle base. When this is done,
you will find that it is not possible to further rotate the
disc by hand.
4.
Permit knob "A" to return.
,3. Close the chamber cover.
6.
Set selective knob (Fig. 8) with the red dot at "A".
7.
Proceed to sew, with complete automaticity.
To remove disc from chamber, first be sure that needle is
out of material, turn zig zag knob (A Fig. 11), till pointer
in dial is at "4". Hold in this position and simply lift disc
straight up and out to remove.
( 7 )
00
o
o
rsj