Removing the work, Preparing to sew – SINGER W761 User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Preparing to Sew
Hold the end of the upper thread loosely and revolve
hand
wheel
toward
you
slowly
until
loop
of
bobbin
thread (Fig. 24) is drawn up through the needle holp.
Draw both threads to the right (Fig. 25
1
and under
presser foot toward back of machine.
Fig25
Fig. 24
Removing the Work
Stop machine w'ith take-up at its highest point. Raise
presser
foot.
Pull
fabric
toward
back
of
machine,
keeping thread in presser foot slot to avoid bending the
needle.
Hold
both
threads
taut
and
cut
on
thread
cutter,
leaving
machine
thread
ends
about
four
inches
long. Never operate the machine when it is threaded
unless there is material under the presser foot.
( 12 )
CO
o
o