SINGER W761 - Manual (Page 14)

Threading the Machine
Fig. 23
Turn the hand balance wheel
: (14) toward you until the
thread take up lever (28) is
raised to its highest position,
i Place a spool of the. thread on
I the spool pin (1) on the top of
I the Machine. (Fig. 23)
' Draw thread through the first
14 ; thread guide pin (2) then
: downward to thread tension
) regulator ( 3) and under the
I same lead the thread from the
I
right to the left between the
I two tension discs. Then pull
I upward passing over the thread
) take-up spring (4) from right
to left.
Lead thread downward again
around underside of thread
; guide (5) and upward through
); thread guide.
Now draw thread from right
; to left through guide (6) and
i needle clamp screw
i 1 ) right
) above needle. Finally thread
I
needle (8) from left to right
- through its eye.
C 11 )
00
o
o