How to insert the needle – SINGER W761 User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
How
to Remove the Shuttle
Fig. 21
i¥hen thread becomes tangled in the hook and shuttle
■ace it is necessary to take the under thread mechanism
ipart and clean it.
:iaise the needle bar to its highest position and tilt the
read back. Remove the bobbin case. Push the screws
>n either side of the race cover to the outside and the
;over can be removed easily. (See Fig. 21), Lift the
rook out.
Brush away all thread and lint from the race, hook and
•ace cover. Then, holding hook by the center pin, place
t in rase so that it fits firmly against driver.
?it cover over pins on each side of the race, with the
rotch at the top. Pull latch screws back over side open,
ngs of the cover.
How to Insert the Needle
Turn hand wheel toward you to raise needle bar to its
highest
point.
Loosen
needle
clamp
screw
and
insert
needle with its flat side to the right or toward the screw.
Push needle up as far as it will go, and tighten screw
securely.
Always
use
the
type
of
needle
recommended
by
the
supplier of your machine. Test on a flat surface to be
sure it is not bent (Fig. 22).
( 10 )
00
О
о