SINGER W761 - Manual (Page 12)

How (o Remove and Replace Bobbin Cate
Fig. 16
To Thread (he Bobbin Cate
Raise the needle bar to its highest position
and lift up the hinged cover plate. Grasp the
bobbin case by the latch and pull out (see Fig.
16). When the latch is closed, the bobbin
falls out of the case readily.
To replace, hold case by latch and place it
on spindle in center of shuttle race. Press fir­
mly before closing latch, making certain that
the tongue of the case fits into notch on the
upper edge of the race cover.
Fig. 18
Refer to Figs 17, 18, 19 and 20 to familiarize yourself
with the procedure. Hold the bobbin case in your left
hand with tongue pointing up.
Let about two inches of thread hang free from the bo­
bbin, and insert bobbin into case, so that thread will be
rotating counter-clockwise.
Guide the thread end through the slot on the side of the
case and under the tension spring until it enters the
small notch on the edge of the spring.
( 9 )
00
o
o